[15000rpms]

everything works. u need 310cc cuz the type s stock is 310cc. You can use ur ep3 harness. works fine. only need type s harness if doing 6 speed for reverse lockout.

 

[15000rpms]

when ephatch.com is back up, go to ephatch for all your ep3 needs. I strongly urge u to stay away from clubep3. Bunch of haters there. I remember the sensors just needed to be switch. I remember it was because the two looked alike. Something of that matter. Its been years, but since the ep3 came with the k-series engine, its all compatible except the clutch. Even the axles are compatible.

 

[15000rpms]

on the clutch, i actually meant to say that: unless you use the stupid oem ep3 clutch, then its fine. All(if not 99%) aftermarket clutches require the rsx type s clutch to mate with ur flywheel.

pretty much u just take out the a3 motor, put the a2 motor in, plug things in. burp the coolant. put in fluids(oil), load k-pro map. good to go.