bseries map pigtail pinned to kseries harness need help

Myknikz · Apr 25, 2015

i bought the 90mm skunk2 throttle body which uses bseries map sensor. i have the pigtail from the bseries harness but i dont know the wires on either harness and i cant find a write up on it and i know its been done before

Myknikz · Apr 27, 2015

Damn no help

crazyjetsfan22 · Apr 27, 2015

You could look in the manual for the pin out on both sensors and put them in the correct order for the B series Map.

Wire-worx also sells a jumper harness for K series to B series.

Myknikz · Apr 27, 2015

Thank you imma look into wire-worx

Sent from my iPhone using Tapatalk

crx_si-r · May 9, 2015

did you get it figured out? if not lmk I can tell where each wire goes.

Myknikz · May 18, 2015

no i did not get it figured out yet...cant find info anywhere

crx_si-r · May 19, 2015

If you still need it I can draw you up a disgram

Mixwell · May 19, 2015

isn't it just two wires...?

crazyjetsfan22 · May 19, 2015

Did a two second google search and found the info

https://www.hondata.com/tech3barmap.html

Wire Sensor Code B Series RSX-S
GND A Green/White Green/White
MAP signal B White Green/Red
5V C Yellow/Red Yellow/Red

bseries map pigtail pinned to kseries harness need help

Top Contributors this Month

Recommended Communities