So I got the EK AC kit, installed it with zero issues. When it came to the wiring, I used the instructions on wiring the relay on the website. Is there a switch I'm supposed to be using as well to kick the compressor, fan on? Only things I wired up was:
12v when car runs to pin85
Ground to Pin87
Pin 30 to C131 pin19 blk red wire
Pin 86 to C131 pin7 blue red wire
I had the unit pressure tested (passed) and then filled with 1.8lbs of r134. I can't get the compressor to kick on or the fan. What am I missing? I'm using the RYwire conversion harness and Kpro.
Edit: so after looking at the CD that the kit came with instead of the online instructions, because I'm using Kpro, looks like I have to re pin 2 wires instead of using the relay supplied. where do I get pins to insert into the kpro harness?
12v when car runs to pin85
Ground to Pin87
Pin 30 to C131 pin19 blk red wire
Pin 86 to C131 pin7 blue red wire
I had the unit pressure tested (passed) and then filled with 1.8lbs of r134. I can't get the compressor to kick on or the fan. What am I missing? I'm using the RYwire conversion harness and Kpro.
Edit: so after looking at the CD that the kit came with instead of the online instructions, because I'm using Kpro, looks like I have to re pin 2 wires instead of using the relay supplied. where do I get pins to insert into the kpro harness?
