Honda / Acura K20a K24a Engine Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
458 Posts
josh green said:
nevermind, how do you get the rsx harness through the eg firewall?
For the eg some remove the ac evaporator part inside the car and use the hole that was originally used for the ac lines. but if you are keeping ac you would probally have to cut a new hole in the firewall.
 

·
Registered
Joined
·
739 Posts
Discussion Starter · #4 ·
well i dont have ac so I guess that clears up alot. I pulled that plug out of where the ac lines run and I see a black thing and a big white thing that you can see under the dash when the glove box is removed. I thought about running then through there but I would like to retain my heat if at all possible. I guess I will take that stuff out and see what it is and if I can run the wires and then put it back in.
 

·
Registered
Joined
·
81 Posts
I cut the boot the factory harness was routed through then taped it up after I had routed the PNP and the main engine wiring harness through it
 

·
Registered
Joined
·
739 Posts
Discussion Starter · #6 ·
hole dosent seem large enough to have all 3 harnesses run through it. I dont want to take the white and the black things out that I was talking about to run the wires. I had though about getting a die grinder and making that hole larger to run all 3 harnesses through. Or just cutting a hole in the firewall and running it.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top