Honda / Acura K20a K24a Engine Forum banner
1 - 2 of 2 Posts

·
Banned
Joined
·
15,815 Posts
It really depends on your budget. I would take it easy and start with the k20a2. Then as I drag that, add cams and ITBS.... The sky is limit after that.. You can built the block,swap the block.. It is important that the car is setup to run with the K. As you have a running car, changing configurations is not very hard to do in my opinion since all the K motors use the same mounts.

SAme people think that they shoild do it right the first time and go with a k24a/k20a2 motor etc... That is fine too.. I just don;t want to end up messing something up and not having a running motor at all. I wold much rather start with a K20a2 or a K24a swap and go from there.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top