Honda / Acura K20a K24a Engine Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
227 Posts
Discussion Starter · #1 ·
I have the k20a jdm typeR engine harness but the problem is that it's too short about 4 inchs where i want it to be (the stock ecu location). So is the rsx-s engine harness any longer?
 

·
Resident Journalist
Joined
·
501 Posts
the k20a2 type s wire harness is hella long... i have to put it in a loom and zip tie is since there is so much extra wires..
 

·
Registered
Joined
·
1,995 Posts
typer0186 said:
I think i should buy one then. thanks
not only that, but wouldnt the JDM K20A harness be designed for the RHD car? as in, the ECU will be on the other side? as in, it shouldnt theoretically reach where you want it to be?
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top