Honda / Acura K20a K24a Engine Forum banner
1 - 12 of 12 Posts

·
Registered
Joined
·
381 Posts
Discussion Starter · #1 ·
can anyone reccomend me a good shop to get some Headwork done on my K24 head.
was thinking about Port and polish

thanks
 

·
Registered
Joined
·
693 Posts
Hey supafly do you have a # for him and can he do the machine work on the vtc from 25deg to 45deg any help would be greatfull
 

·
Premium Member
Joined
·
7,171 Posts
Ben Howard said:
Brad from RLZ is where i spoke.

Some people have mentioned loosing power from headwork. Something about doing the job incorrectly.
More along the lines of not gaining power. The K heads have been shown to flow very well, and for the most part can out flow the stock block or even a mild build. SO the benefits won't be seen unless you have a decently built block to go along with your reworked head...

Or at least that is what I have seen so far...
 

·
Banned
Joined
·
15,812 Posts
RLZ does great work from what I heard but my friend's head has been there since may.... so I think he is too busy
 

·
Registered
Joined
·
805 Posts
ive heard portflow does a good job, and if i remember correctly is was Tbone who had his head reported by RLZ and gained a shitload of power over his original ported head....
 
1 - 12 of 12 Posts
Top