Honda / Acura K20a K24a Engine Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
565 Posts
Discussion Starter · #1 ·
at the moment I'm doing some research on wheelie bars and was wondering what sort of info people had on them..
From a small amount of research I've done so far it seems a common length of around 60-65" is used, but so-far have only heard of a 150-200lb rear spring being used.

Personally I think I will run a set-up similar to Norris and Skunk2 using a single bar set-up. But was wondering if anyone had pictures of where they attach to the axle and cage. And also if anyone had any info on what sort of spring rates to use.

Gary
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top