Honda / Acura K20a K24a Engine Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
221 Posts
Discussion Starter #1
I am looking to quiet down my current setup and clean up the tone a little bit. The current setup is kind of chop shopped right now and has different kinds of piping on it... not my fault... Anyways. Was just curious as to what resonators people are running I ran a 14" Vibrant Bottle style and wasn't too impressed with the performance, and want more out of it... I currently have a Apexi WorldSport II 3" in/out muffler, so I know the muffler is going to do it's job as far as muffling goes, I just want a better resonator to compliment it. And I figure with having 3 different kinds of piping, differences in the mandrel and crush bends and the different kinds of piping, some thicker than others. Is also probably affecting my exhaust note. Anyways thanks for the input!
 

·
Registered
Joined
·
21,788 Posts
I had a flowmaster resonator on my old set up. wasnt very loud, but was still noticable when I was on it. I got it from Summit, it was for a mustang
 

·
Registered
Joined
·
221 Posts
Discussion Starter #3
3" exhaust is always going to be loud on WOT I am just more worried about cleanness of the exhaust note and what not and how quiet it is under normal operation.
 

·
Registered
Joined
·
197 Posts


this one should do a pretty good job alot better then the straight thru bottle style resonators, if u have enough room down there to put it in.
 
1 - 10 of 10 Posts
Top