[Matador]

Well when i get my swap im probably not going to have enough dough to buy a new clutch, are any of you guys using the stock R clutch? Is it good enough to hold the power of bolt ons? I probably wouldnt even change the stock flywheel which is 10lbs i think and is light enough for me. If i do go with a aftermarket clutch it would be a Action one. Probably the Kevlar stage 1. Are any of you guys using action cluthes?

 

[Dc5itracer]

im most likely going for a exedy cerametallic with flywheel :up:

 

[non vtec]

I run a really HD ATS single plate. Although looking at it today i think I will need to upgrade to a Twin plate very soon..

 

[909edge]

If I recall correctly Pacman used the stock R clutch for the whole time he had the crx and he said it held pretty well. They had alot of passes on slicks...

I'd like to get a Tilton twin-disk but I can't afford that shit. For anyone who can, I think Camp1320 carries them...

 

[Matador]

You dont think the tilton would be a little too much clutch for your daily driving needs?

Yea im going to try the stock clutch and see how she blows.

 

[Kedimoto]

Competition Clutch twin disk ceramic, my motor is not built or running yet but Im in the process of collecting parts, going in my all motor race 92 civic.

 

[.y2a.]

Competition Clutch twin disk ceramic, my motor is not built or running yet but Im in the process of collecting parts, going in my all motor race 92 civic.

:wow: :wow: :wow: :wow:

 

[TeamPacman]

If I recall correctly Pacman used the stock R clutch for the whole time he had the crx and he said it held pretty well. They had alot of passes on slicks...

...

TRUE TRUE :up:

 

[TeamPacman]

You dont think the tilton would be a little too much clutch for your daily driving needs?

Nothing is too much...

 

[nikos]

Competition Clutch twin disk ceramic, my motor is not built or running yet but Im in the process of collecting parts, going in my all motor race 92 civic.

Damn dude.. That is one of these posts I like to see... WOW..

Are these TWMs? If so, IM me if you read this. I want to tell you something.

 

[vaughn4]

i am running the Exedy stage 2..... hooks awesome and quite drivable.

 

[11sec CR-X]

ACT hd six puck here with the 8 lb flywheel..

 

[k20em2]

Competition Clutch twin disk ceramic, my motor is not built or running yet but Im in the process of collecting parts, going in my all motor race 92 civic.

Kedimoto,

How much did that twin disk cost? I wanted to get an exedy twin disk, but it hasn't been released yet. So I settled for the exedy hypersingle. I've already gone through 2 exedy ceremetallics.

Anyone know any other twin disk clutches out for the k-series?

 

[1fstEP3]

Clutch Masters twin disc in the EP and EK.

 

[Kedimoto]

Kedimoto,

How much did that twin disk cost? I wanted to get an exedy twin disk, but it hasn't been released yet. So I settled for the exedy hypersingle. I've already gone through 2 exedy ceremetallics.

Anyone know any other twin disk clutches out for the k-series?

the competition clutch cost me 1250, i know clutch masters make a twin disk also.

 

[optimus]

I'm running the exedy stage 2 (cerametallic 3puck sprung clutch) & ACT 8lbs flywheel. Good clutch, held the power I was putting down and I've used them on all my mild to wild b-series motors as well. I'd advise you replace the clutch before putting in the motor. I ended up with a k20R that had a toasted clutch and make a mistake of not replacing the clutch on the motor before I swapped it in the eg. I had to pull the motor out again to replace the clutch.