Honda / Acura K20a K24a Engine Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
128 Posts
Discussion Starter #1
Hi

Does anyone know what the angle is between the inlet and exhaust valves? Also is it possible to get 16:1 pistons and how, where etc?
 

·
Registered
Joined
·
128 Posts
Discussion Starter #6
Thanks for the welcomes :)

I can have the chambers probed and then design something around that but if there is something on the market that will work that would be a lot easier, and cheaper.
 

·
Registered
Joined
·
128 Posts
Discussion Starter #7
Okay for anyone interested, I measured it at 50 degree, but could be off by 1 or 2, but close enough for me...
 
1 - 7 of 7 Posts
Top