Honda / Acura K20a K24a Engine Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
129 Posts
Discussion Starter #1
Hello K20 fam...I know there is alot of knowledgeable people on here so I need some advise. I'm using a Rbb TSX head on my engine setup. I have a Type s intake manifold on it but it leaves 2 little coolant passages exposed on the end of the head. What should I do? There is one bolt hole on the corner of the head I can use for a custom block off plate but I don't think it will be enough...I posted the same thread in engine building forum with pics..Any help would be appreciated.. .Thanks guyz.
 

·
Registered
Joined
·
1,026 Posts
Get a uncut RBC and it will work fine.
 
1 - 3 of 3 Posts
Top