[latino honda]

I want to adjust my tps on my k20a2 in my ep3 but it's so difficult. It's on kpro with a base tune haven't done anything yet. I haven't replace any of the parameters only thing I did was put the engine type added the 550 injectors and and adjusted the radiator turn on earlier the car tents to sputter at the beginning
I figure it is the tps since I had to replace it. Any suggestions would help but other than that the car drives fine

 

[kpoweref8]

Assuming you replaced the tps under the tps tab

At the very bottom it allows you to calibrate close throttle and WOT.

Click on read at closed throttle and set it to 0%. If need to adjust tps, do so. Once that's set, do the WOT and click read. Should be 100%

 

[latino honda]

What is the tps tab you mean.also when I calibrate it on kpro it doesn't stay 0 and 100%

 

[kpoweref8]

That's why you have to keep adjusting the tps til it reads 0

 

[hapino808]

i think i have the same issue. my tps reads 38% closed and 0% WOT but almost to WOT it reaches 115% then 0% at WOT so it jerks right after

 

[hapino808]

how do you adjust theTps?