Joined
·
2 Posts
swap k20a in for k20z3 out, what all is needed to swap? manifolds, transmission ...
swap k20a in for k20z3 out, what all is needed to swap?
1 - 1 of 1 Posts
1 - 1 of 1 Posts
Join the discussion
Recommended Reading
-
K24a2 swap into EM1 hp/tranny questions
All Motor K series Technical DiscussionHey guys, long time lurker here. Swapping in a K24a2 from a 05 TSX into my 00 em1. I was wondering about how much hp/tq this motor should make with the following mods (already bought) and was curious about the positives and negatives of the 6 spd vs 5 spd in this car, not sure if I'm going turbo...- 11
- 392
-
CrispyCreamy · updated
-
K20A Type R wit KPRO. P1362 and P0340
All Motor K series Technical DiscussionHey everyone, Been a long few weeks... I just put a k20A type r motor I bought from a reputable shop in my car. Its the second one of these engines Ive had in it. It has been running great all week.. the motor is super quiet and sounds amazing. Tonight on my way home from work I hit the rev...- 21
- 535
-
K24 Main Bearings Out-Of-Round
All Motor K series Technical DiscussionI'm now measuring the main clearances on a k24 using a .001" bore gauge and .001" micrometer. The vertical height of the first main is .013". The first main measured with the bore gauge rotated to 3:30 aka approx. 105*, reads .021". The bore gauge is definitely reading correctly; the tangs/oil...- 1
- 52
-
bemmis · updated
-
K24a2 - Where is the torque?
All Motor K series Technical DiscussionK24a2 swap into a Toyota Supra chassis. Running Megasquirt EVO. Dyno is a Dynapack using no correction factor. Uncorrected dyno numbers are 180hp/135tq. Cam timing is spot on. Injectors were cleaned. New spark plugs. Good compression. 50 degree VTC gear with 40* Tractuff limiting pin 70mm...- 6
- 448
-
K20A2 Motor / Map problem! Can't figure it out.
All Motor K series Technical DiscussionHi, I've been struggling for 2 months now on the motor. Just trying to see if anyone could help since I can't seem to find the issue. The motor is recently rebuilt with new / aftermarket parts. I'm also currently working with my tuner (e-tuned) so I can at least drive it for now to break in...- 1
- 196
Join now to ask and comment!