Honda / Acura K20a K24a Engine Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
172 Posts
Discussion Starter #1
ok so i been wanting to put my built motor in my car. its stock sleeves with wisco 9. 86.5mm pistons and pauter rods. now since its stock sleeves and i want to push like 650whp will a block guard help or is it not even not worth the extra 100 bucks
 

·
treblictuned
Joined
·
1,422 Posts
it does work but save up for some sleeves. Check out erl performance they have the best block and support

dont use one, at that power level if it detonates the stock sleeve it gone regardless. Just get it sleeved and dont worry about it.
 

·
Registered
Joined
·
1,109 Posts
ok so i been wanting to put my built motor in my car. its stock sleeves with wisco 9. 86.5mm pistons and pauter rods. now since its stock sleeves and i want to push like 650whp will a block guard help or is it not even not worth the extra 100 bucks
Well, first you have to change "b20forlife" to "kseries4life" then I am sure you can get a block.

Honestly, for hands down the best service, best quality, best everything and a good conversation call up Sean. Here is his info.

Sean/Seth Phone #812-948-8484

They stock the blocks too.
 
1 - 6 of 6 Posts
Top