Honda / Acura K20a K24a Engine Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
Our pistons do not have .005" clearance in a stock block. You cannot measure piston to wall clearance with a feeler gauge. The block has to be measured with a dial bore gauge, and a mic for the piston. The piston on that particular part number has to be measured 0.400" up from the bottom of the skirt. Nobody is SOL, if our pistons don't measure to what our specification sheet has printed, return them.

You guys should contact the manufacturer first, it would lead to less headaches.

Darius

CP Pistons
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top