Honda / Acura K20a K24a Engine Forum banner
1 - 2 of 2 Posts

· Registered
253 Posts
Discussion Starter · #1 ·
Just wanted to know what you guys think about a .040 overbore(87->88mm) on stock sleeves in a built all motor car.

I didnt have any problems with a 1mm overbore on the K20a, but i just thought I would get your opinions.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.