Honda / Acura K20a K24a Engine Forum banner

some pictures of my rocket ship and a little review of my h-p itbs.

4469 Views 38 Replies 25 Participants Last post by  zjigg1k
all right guys here are some pics my budy eric snapped today....



















the itb's are absolutly amazing, verry smooth and fit great(one dent under the hood on the webing was needed though to clear). some of you might have seen my car before with it had twm's on it. personaly for a daily driver i would have to say the hayward one's are the way to go but for a race car the twms would have it..

Attachments

See less See more
14
1 - 10 of 39 Posts
i will be running screens on them for filters but i think an itg single plate or sock type filter would fit fine. they cost just above 2k for every thing shipped from hayward performance, that's just above twm and below toda, the price verries depending on the size and linkage setup. with these one's i can now put a hood back on my car and the throttle is smooth like stock. the twm's are a straight line threw the port design, with a flashlight i could literaly see straight thew the throttle plates and threw the valves to my piston, although they do have the ushual twm sticky throttle(not bad, just had to tap the throttle to bring down the idle). that's why i would recomend them for race and these for street.
it's a hytech muffler with two small mufflers under the car. sounds just like stock. the motor it self is louder than the exhuast..
i'm running a k-pro right now but will be switching over to an aem ems as soon as i can come up with the funds. the price is regular but it is one of the first made so prices can change.. thanks for the complements.
it was verry verry simple, just had to take the studs out of the intake side and replace them with bolts, and put it on like a regular manifold.
k20spooner said:
With ems will it still run as smoothly, be emission friendly and not require a hack job for wiring? Like if I plans of doing itb's should I just put in a ems instead of kpro or is kpro good enough, the car will be a weekend car and show queen, not trying to squeeze every last bit of power out.
thanks again
it shoud run as smooth if not smoother, i will be able to adjust the gian on the tps and map so i can run a tps based map that is map assisted. the k pro would work fine really i'v just been running the aem system for my last couple of builds and have grown to realy like it. o'h it will be there direct plug in system..


thanks for all the nice remarks and complements, it means alot..
i'm not shure about the total cost, i got hooked up with alot of the stuff, quite a bit though i'm shure. havent put down any numbers or ran it for time's yet either. so i guess i'm not verry helpfull lol..
no problom, my pleasure..
^^ that was actualy me posting ^^ lol, i just notice i was signed in under the wrong person.. haha.
thanks katman, i'v been running the ems for the last couple of weeks and i love it. it's a great piece.. <3
1 - 10 of 39 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top