Honda / Acura K20a K24a Engine Forum banner

1 - 19 of 19 Posts

·
Registered
Joined
·
266 Posts
Discussion Starter #1
hey i have a slightly used skunk2 kseries intake manifold forsale. just used for a dyno test between this and an rbc. it made the same power with a little more midrange on my stock k20a2 compared to my rbc. will make really good power over a stock manifold. eliminates problems like crx hood fitment or k24 into integra hood fitment. also you dont need an adapter plate like with an rbc

asking 350 shipped thats deals only for k20a.org!!!





 

·
Registered
Joined
·
989 Posts
Nice :up:

Would have took this but i already sent my RBC off to get a ported one :up:
 

·
Registered
Joined
·
373 Posts
is this manifold any shorter width wise when compared to the rbc? with an rbc I have to trim my radiator support to make it fit. if i could avoid doing that with this manifold that would be very nice.
 

·
Registered
Joined
·
3,120 Posts
You should bring it by the shop so we can flow it before you sell it. Ill flow it for you for free and you can include that with the manifold when you sell it.

Stefan
 

·
Registered
Joined
·
354 Posts
bump this manifold has more material to get ported open.. good luck
 
1 - 19 of 19 Posts
Top