Honda / Acura K20a K24a Engine Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
537 Posts
Discussion Starter · #1 ·
Hey guys K20EG led me to this site...thanks.......again lol.

Well were just starting to build a k24/k20 head engine. Actually the engine has yet to arrive. We thought perhaps that the s2000 pistons might fit into the k24 block...any thoughts?

We'll be able to find out more once the engine arrives but hey thought Id ask.

Anyone have any comments on perhaps some pit falls to look out for, or perhaps a little knowledge on maybe getting a few more horses without making me completly broke :p

BTW any thoughts on these mounts?



I was also wondering if anyone is going to break the rules and not go with the urethane mount inserts...I was thinking of something with more of a stock feel.[/img]
 

·
Registered
Joined
·
537 Posts
Discussion Starter · #10 ·
brian g said:
The pistons will fit, but the super long stroke of the K24 combined with the high pop-up dome on the S2000 piston would most likely yeild an excessively high compression ratio.

brian g
Hmmm. Well we decided to go a different route. What do you think of 11.1's in there?

Thanks.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top