Honda / Acura K20a K24a Engine Forum banner

ROTREX with WG + 4 port solenoid how to connect

3581 Views 15 Replies 8 Participants Last post by  Accordk24
Guys i have no idea how to connect WG with 4 port solenoid in my rotrex setup!
WG will be use for BBG and for boost cut
Coud someone help me????

I found this but one pipe goes to turbo!!! With rotrex where i have to connect this pipe????
See less See more
1 - 1 of 16 Posts
If there's a nipple on your compressor housing it would go there, if not I think you could weld a fitting in the pipe just after the compressor exit.
1 - 1 of 16 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.