[mw1978]

Guys i have no idea how to connect WG with 4 port solenoid in my rotrex setup!
WG will be use for BBG and for boost cut
Coud someone help me????



I found this but one pipe goes to turbo!!! With rotrex where i have to connect this pipe????

 

[zerotraction]

If there's a nipple on your compressor housing it would go there, if not I think you could weld a fitting in the pipe just after the compressor exit.

 

[rbsjnh]

any port which see's boost and vacuum would work, just tap your brake booster line

 

[mw1978]

sorry for stupid question but where is brake booster line
here is my engine bay
So far i know that i have to connect hose from dump valve with hose from intake manifold

 

[rsamd]

connect it where u put the bov. i put mine to the hose between crank case pcv and intake mani.

 

[preston]

sorry for stupid question but where is brake booster line
here is my engine bay
So far i know that i have to connect hose from dump valve with hose from intake manifold

what kit is that? never seen this setup before?

 

[hondaluver]

tts for a k20z1

 

[mw1978]

This is new TTS kit for euro CTR but fit also in SI 2006-2012 (k20Z3)

 

[hondaluver]

opps yea, z3

 

[preston]

i'm new to the rotrex stuff, but is it possible to rock that setup with other K's, or is it only k20z3 and euro r specific? sorry if that's a dumb question.

 

[rbsjnh]

i'm new to the rotrex stuff, but is it possible to rock that setup with other K's, or is it only k20z3 and euro r specific? sorry if that's a dumb question.

absolutely, its intended to keep ac, but must have eps or manual steering as pulley placement eliminates ps pump location.

tap the vacuum source on top front and center of the mani.

 

[preston]

absolutely, its intended to keep ac, but must have eps or manual steering as pulley placement eliminates ps pump location.

tap the vacuum source on top front and center of the mani.

i gotcha. i kinda like this location for the ease of intercooler piping, air filter location, and not having to cut up my subframe for bigger blowers.

 

[timot_one]

i gotcha. i kinda like this location for the ease of intercooler piping, air filter location, and not having to cut up my subframe for bigger blowers.

Good for twincharging with a roots blower too. :up:

 

[hondaluver]

actually, no you can't, you have to use a Z3 head, it connects to the head, it will not work on a k20a2 head. I also emails them and they have no intention of making a simular kit for a k20a2.

 

[timot_one]

There's always the option of fabricating the mount for a k20a2 head. Can you take some better pictures of how it mounts to the z3 head?

 

[Accordk24]

Does this work the same as the Turbonetics Godzilla BOV?