Honda / Acura K20a K24a Engine Forum banner
1 - 6 of 6 Posts

· Registered
Joined
·
57 Posts
Discussion Starter · #1 ·
I have a 96 GSR sedan with a K20A2 swap using a R-Crew header. The header sits very low and to bring it back up to meet the existing piping this pipe was needed to be made. I am using the Hasports mounts incase that makes a
difference. I enclosed a picture to show everyone the problem.

Is this common?
What could this be?
Or just a cheapo header?

 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top