Honda / Acura K20a K24a Engine Forum banner
1 - 7 of 7 Posts

· Registered
Joined
·
641 Posts
Discussion Starter · #1 ·
Ok I need to double check how to route my fuel lines. In the pic. below you can see the three lines coming from the Eg's fuel tank. Starting from the left we'll number them from 1 to 3.
So, line 1 goes to fuel rail ( i am eliminating fuel filter)
line 2 goes to the return on the FPR
where does line 3 go???

 

· Registered
Joined
·
1,990 Posts
from left to right:

1 - Fuel Feed line

2 - Fuel Return line

3 - fuel vapour (DO NOT PLUG THIS, AND DO NOT LEAVE IT OPEN IN YOUR ENGINE BAY), which should be directed under the car or out the side of the car since fuel vapour will be comming out of this tube. normally (OEM) this is hooked up to what is called a charcoal canister, however it is not nessisary and can jut be removed (unless you are trying to pass emissions!)
 

· Registered
Joined
·
641 Posts
Discussion Starter · #7 ·
Can I just cut it at the end of the vehicle near the tank?? Why can't I plug it??
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top