nope sorry - what you are referring to is the intake piping NOT the velocity stack. as I stated in that thread...the piping was custom made by the shop that installed itTrueZen said:5. I really liked the post on intakes and the pic's with the Prototype Racing velocity stack. The stack though is just the straight section of pipe, correct? If so, would anyone be able to suggest a good place to look for similar aluminum piping? Or could I just get two vel. stacks and mandrel bend one of them?
I had another question which I can't remember right now, but I'll post up later if I can remember it.
the velocity stack looks like just a horn - its the piece on the right
here is what what it looks like attached to the intake tubing
you can basically buy a large sized K&N filter that will fit over the stack