Honda / Acura K20a K24a Engine Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
122 Posts
brax90si said:
If i use this pulley can i use the serpentine belt that came on the engine, or would i need to get a different sized belt? thanx for all the input it helps out alot.

-Braxton
If you use the EP3 idler pulley, you need to get another belt that is 50.5 inches long and 7 rib. You can get it at Kragen. I have posted part numbers in the past. too lazy to look right now
 

·
Registered
Joined
·
122 Posts
ok so i'm not that lazy. here it is:

should be 50.5 inches


I posted this before but you can get the belt at Kragen

The belt part number is 5070505.

the 7 = 7 rib
505 = 50.5 inches

pic of setup(using a stock pulley but the AEM should still work)

 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top