Honda / Acura K20a K24a Engine Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
hello, im totally new to the board..

i was wondering if anyone had any type of issues with the main pulley of k20a in their em2 (01-03 ex 2d civic) and the hood clearnce?.. I used hasport mounts and the engine went in just great.. although the top pulley is a little to high up and i think i will have to make sometyype of a hood scoop.. or cut the buttom part of the hood wich i dont think is going to give enough space.. this is a totall bummer..

anyone dealt with this before? am i going something wrong?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top