Honda / Acura K20a K24a Engine Forum banner
1 - 1 of 1 Posts

· Registered
1 Posts
Have you got any pictures of this? I need an intake manifold that sits marginally lower than the stock one. I have a k20 in my gen 2 crx and the hood hits on the pipework that comes from the top of the IM. I'm looking for one that sits slightly lower, hopefully will give good gains and doesn't cost the earth. Then I'll get a new bomnnet and it won't dent :).
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.