Honda / Acura K20a K24a Engine Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter #1
I cant find any information on this manifold other then "RBC is better" does anyone have dynos with this prc intake manifold with a k20a2? Anyone suggestions other then the rbc ...just want to know some differences in gains and where the gains r.
 

·
Premium Member
Joined
·
44,706 Posts
http://k20a.org/forum/showthread.php?t=3025
That was back in May of 2005, so almost 6 years ago. Since then, the RBC has been much easier to get. At the time it was not available in the North American market, and had to be imported, so there was little data on it. The PRC is better than the PRB, but the RBC is better overall. I know that there were dyno plots comparing them, but it has been so long ago I would have to dig pretty deep here to find them.
Edo was using the PRC on a lot of builds back then, so I would search for threads started by him :up:
 
1 - 5 of 5 Posts
Top