[11sec CR-X]

which sensor is right next to the map sensor. it has a vaccum port coming off of it. Where did u guys run the vacuum port to. mine is exposed.
any help would be greatly appreciated.

 

[Rubber Chicken]

Purge valve - it goes to the canister. The plastic fitting on the end has a habit of breaking off easily. The ECU opens it under certain running conditions to suck gas vapor from the charcol canister into the engine. It is not vital for the operation of the engine, but it does no harm so I always leave the purge valve alone. If it is disconnected then eventually you get a check engine light (but not always for some reason).

 

[overlap..]

helpful link picture with sensor vaccum attached.
http://www.k20a.org/forum/showthread.php?t=1640&highlight=broke+sensor

OR...
you can just take it off and cap the throttle body. Which frees up those black rails from on the cylinder head. take that off too while your at it.
http://www.k20a.org/forum/showthread.php?t=2484

*need kpro to disable engine code.

how do you put the image just on the thread again? i forgot.

 

[11sec CR-X]

Thanks guys for the info. Mine is just open might just remove it. thnx

 

[AdEgk20]

i put mine to tha fuel paurge thing on tha firer wall.