Honda / Acura K20a K24a Engine Forum banner

OK... whos actually done the OEM axle combos?

1459 Views 19 Replies 13 Participants Last post by  mt72
I tried separating the outers with absolutely no luck! the lip actually dented quite a bit from hitting it so hard repeatedly...

anyone have any tips, or did anyone else have any problems? right now i feel like i was doing something wrong, i must have hit it as hard as i could with a sledge about 15-20 times :(
1 - 1 of 20 Posts
you should turn the axels around and hit the outer's evenly. ALso, it's going to take awhile if you do not have the axels clamp down with the table vise grip.
1 - 1 of 20 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.