Honda / Acura K20a K24a Engine Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
203 Posts
Discussion Starter · #1 ·
I am in the process of disconnecting my wiring harness. The small White plastic clips annoy the fuck out of me. Some of these are green and I have seen one brown one but the majority are white/Clear. I used a pair of needle nose pliers to hit the easiest clip out of the whole. This worked.... however it did not go out all the way. So i would hit it until it was half way out. When I proceeded to grab it it would slide right back in like a ghost was fuckin with me. Is there some tool that I do not know about? These Clips are small and made of plastic. They have a circular ring around them. Also, Not pulling hard enough is not the problem. Believe me I had plenty of force. If anyone knows any tricks or secrets to these little fucks that would be great. Sorry. just frustrated.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top