Lowering Constraints with K20

1446 Views 11 Replies 7 Participants Last post by realek4, May 13, 2005

AutoX_Acura

Discussion Starter · May 9, 2005

Does the K20 sit pretty low in a DC2 chassis? I have seen pictures where the oil pan isn't very high off of the ground at stock height compared to b-series motor, so if you lower the car will you have clearance issues, even possibly the oil pan hitting the ground? How low can you go without hitting things easily?

Save

1 - 2 of 12 Posts

jon v

· #8 · May 11, 2005

I believe they move the motor back and up a little. So yes it should provide with a little extra room between the mani and the rad/rad support...

Save

jon v

· #10 · May 11, 2005

drhonda said:
Do you think there is more room in that car with that setup than with an eg? in the front there?

It looks like it but you should just look around a little at some pictures and see how it looks in the EG.

Save

1 - 2 of 12 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month