Honda / Acura K20a K24a Engine Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
86 Posts
Discussion Starter #1
so, im gonna swap :
k20z1+04 type s tranny+ep3 engine harness

into my ep3.

for ecu

should i do the kpro addon board, or is there any benefit to the full kpro ecu over the board?

i ran neptune in the past on my turbo B series, it was an addon board - and i had great success with it....

thanks guys!
 

·
Registered
Joined
·
457 Posts
if you are talking about the K100 which is what it sounds like, then you wouldn't get the "full" tuning capabilities if you were to get Kpro. you would have to use someone else's Kpro to tune your vehicle then that tune would have to be transferred over to your ECU. the K100 does not have datalogging capabilities nor will you be able to adjust fuel and ignition maps. you will just be able to load/flash up "custom" calibrations.
 

·
Registered
Joined
·
152 Posts
From the Hondata website:;

Note: The k100 is a product designed for use in certain situations only (Europe and Asia). Most people are advised to consider the reflash or programmable ECU. The k100 is not available in North America.
 
1 - 5 of 5 Posts
Top