Honda / Acura K20a K24a Engine Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
194 Posts
Discussion Starter #1
Can anyone help here? I can't find this in the manual. It is shown clearly in the connector location manual, but not listed in the wiring manual, unless I'm just not looking in the right place. Can't find anything meaningful online.

Just trying to figure out whether I need to remove these from the ECU end & relocate/reroute by the starter harness (which will go into the cabin), as this is a mid-engine install. ECU & relays will be in trunk, but OBDII, gauge (MIL, tach, speedo, coolant temp, OP, etc) signals all need to go forward.

Any pointers?
 
1 - 1 of 1 Posts
Top