Honda / Acura K20a K24a Engine Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
24 Posts
Discussion Starter · #1 ·
what are the differences between the tsx and type r heads?

what about the block?

i want to go k series but i want to do it once and right. by adding type r internals to the tsx head, will they be the same? also with the block?
 

· Registered
Joined
·
24 Posts
Discussion Starter · #9 ·
jon v said:
Yes... You will use all the same cams, springs, and retainers. The TSX head stock should produce a little more torque because of the smaller ports, but once you start working on them they can be built just aqbout the same...

:cool:
oh ok thanks thats what i want to know. i might as well just get a tsx long block along with the ep3 tranny.


can you put k24 crank and rods into the k20a? whats the r/s of the k24 anyway?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top