[rhdcrx]

hey i want to but my prb manifold on my k24a2 but i forget who makes the special gasket with the water jacket piece if anyone has/ can tell me who makes one so i can change my manifolds so my hood will shut lol
any help is greatly apreciated

 

[KOOCHYOLOGIST]

hey i want to but my prb manifold on my k24a2 but i forget who makes the special gasket with the water jacket piece if anyone has/ can tell me who makes one so i can change my manifolds so my hood will shut lol
any help is greatly apreciated

hasport:up:

 

[rhdcrx]

hasport:up:

thanks will check there website and order one ^^

 

[KOOCHYOLOGIST]

anytime:up:

 

[rhdcrx]

one more question can i use a PRB manifold + the RSX water jacket piece rather than buy the adapter plate?

 

[02ep3si]

no.. but you can tap the head and put your own water fitting on there to run a coolant line out.

 

[rhdcrx]

no.. but you can tap the head and put your own water fitting on there to run a coolant line out.

and that actually works lol i need to pull my manifold off and see this

 

[02ep3si]

http://www.k20a.org/forum/showthread.php?t=2706

check that thread and look at the pics.. it shows where it was tapped and fitted with a 90 degree fitting.

 

[rhdcrx]

http://www.k20a.org/forum/showthread.php?t=2706

check that thread and look at the pics.. it shows where it was tapped and fitted with a 90 degree fitting.

OMG man nice thanks for the link to this thread will be going this rout for sure

 

[02ep3si]

NP... glad i could be of service.

 

[rhdcrx]

just thought i would post some pictures and a little how too

i used a 3/8ths pipe thread 90 degree fitting with thread sealer
also used a 3/8ths pipe thread tap
here are some pictures of how it turned out

hope this helps everyone and thanks for giving me the idea to go about this issue in this manner.

 

[KOOCHYOLOGIST]

^^^^^:up:

thanks for the info

 

[02ep3si]

just thought i would post some pictures and a little how too

i used a 3/8ths pipe thread 90 degree fitting with thread sealer
also used a 3/8ths pipe thread tap
here are some pictures of how it turned out

hope this helps everyone and thanks for giving me the idea to go about this issue in this manner.

no problem man.. glad i could help you out there.

 

[rookiepains]

if you decide to run the hasport plate ,i have one nib

 

[talonxracer]

And if you want something a bit more snazzy you can drill and tap the hole for a 3/8"npt and use AN fittings.