Honda / Acura K20a K24a Engine Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
ok.. here it goes...

Ive got a k24 from a CRV.. the timing chain slipped about 15 teeth...

the big question is, is a k24 an interference or non-interference motor? The swap did still run after the timing chain slipped but VERY poorly...

do i have fail sauce valves/pistons or can i put this bad girl back in time and have a running swap?
 

· Registered
Joined
·
10 Posts
Discussion Starter · #3 ·
you can try and put a new chain and tensioner on it.

but you may have valve damage and piston damage...
knowing weather its an interference or non-interference motor will answer the question about valve/piston damage...

i just dont want to buy a new chain and tensioner if there is alot of internal damage...
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top