So I’ve just gone from k20 swap ek to k24 block k20 head the only thing is my gearbox from the k24 is auto will my ep3 k20a2 gear box bolt straight up and that’s it? I’m only asking cus my mate said I need a bush to convert to manual?
Will bolt directly up. Just get a pilot bearing for the crank for the snout of the input shaft to ride on. Automatics don't use em with the torque converter.
Edit. Will also need a clutch and flywheel obviously but also manual flywheel bolts. The auto bolt used on the flex disc are not the same as the manual ones for a flywheel.
Cheers for the quick reply mate ordered the part just now, will I need to remove anything before installing the bearing? And yeah I’ve got k20a2 gearbox,clutch,flywheel and bolts
I'm 99% sure that the torque converter mates up with no bushing in the crank. You should be good to go. Don't forget the alignment dowels for the bell housing
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Honda / Acura K20a K24a Engine Forum
2M posts
94.7K members
Since 2000
A forum community dedicated to Honda and Acura K Series engine platform owners and enthusiasts. Come join the discussion about performance, modifications, troubleshooting, power-adders, racing, maintenance, and more!