Honda / Acura K20a K24a Engine Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
157 Posts
Discussion Starter #1



well this my new 500 whp k20a2 turbo setup
motor is built has 1800 miles on it run great not bad for low compression but i need a turbo now
k20a2
Manley I-Beam Rods turbo tuff
Wiseco 9:1 pistons
AEBS Sleeves
Honda Bearings
Honda Water Pump
Honda Oil Pump
Honda Timing Belt Tensioner
Honda Main Seal
Bore and Hone
Blueprint and Assembly
OEM Honda headgasket
Supertech Valvesprings, seats, retainers
stock cams
how much power can my tranny handle?
act clutch flywheel, brand new gears and sync, quife lsd
and whats a good suspension?
 

·
Premium Member
Joined
·
7,171 Posts
It's kind of a generic type question... It really depends on the condition of the tranny, how you drive the car, and what you use it for... Not sure nayone can say 400 or 500hp is fine on these trannies. Its really a case by case type of deal...

If it's in good condition and you take care of it and baby it it should last a while... If your going to the track a lot and doing 2nd gear burnouts on slicks it's not gonna last as long...
 

·
treblictuned
Joined
·
1,422 Posts
alot depends on driving style and conditions. My 6speed was was fine at 530whp, but too short so switched to 5speed
 

·
Registered
Joined
·
401 Posts
Mine lasted 2 700 whp pulls on the dyno and bang, replaced it with a ep3 5 speed, its holding up much better
 

·
Registered
Joined
·
157 Posts
Discussion Starter #7
thanks guy ill stick around 500hp
 
1 - 7 of 7 Posts
Top