Honda / Acura K20a K24a Engine Forum banner

K20a2 Race Exhausts in an EG - Do I use an O2 sensor?

2K views 9 replies 5 participants last post by  2fastxeg 
#1 ·
Did a few searches but didn't find exactly what I was looking for. I'm looking at race exhausts for my swapped EG and I'm not seeing bungs for the O2 sensor. Where am I getting my readings from for K-Pro and such? Do I just buy an AEM wideband and have a bung installed? If so, where on the pipe?
Anyone with some knowledge on this would be great!

Edit: Image Example from Six Sigma (DTR)




Thanks,
Steve
 
See less See more
1
#3 ·
I was looking at the new header, but I need one like I displayed. This is for an all motor drag car.

However, I just need to know if the O2 sensor is will be added just past the collector or if there is a better place to put it on a configuration like that.


Steve
 
#4 ·
If you want to extend the wires just put it after the flange...
 
#6 ·
my bad i was thinking you were going to bolt it up to a full exhaust...

yah you would have to put it in right in or after the collector, which unless you could angle it or something may impede the exhaust flow a little?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top