[k-series]

Did a few searches but didn't find exactly what I was looking for. I'm looking at race exhausts for my swapped EG and I'm not seeing bungs for the O2 sensor. Where am I getting my readings from for K-Pro and such? Do I just buy an AEM wideband and have a bung installed? If so, where on the pipe?
Anyone with some knowledge on this would be great!

Edit: Image Example from Six Sigma (DTR)

Thanks,
Steve

 

[chameleon]

check the other thread out for his new cheaper header, btw their custom for a reason when you have them made you tell them what you want and how you want it.

 

[k-series]

I was looking at the new header, but I need one like I displayed. This is for an all motor drag car.

However, I just need to know if the O2 sensor is will be added just past the collector or if there is a better place to put it on a configuration like that.


Steve

 

[jon v]

If you want to extend the wires just put it after the flange...

 

[k-series]

If you want to extend the wires just put it after the flange...

What flange? The exhaust flange? I don't think I'm following since there isn't a flange on the race header/exhaust I'm showing.


Steve

 

[jon v]

my bad i was thinking you were going to bolt it up to a full exhaust...

yah you would have to put it in right in or after the collector, which unless you could angle it or something may impede the exhaust flow a little?

 

[k-series]

I'll have to talk to Danny about that.

Steve

 

[chameleon]

I'll have to talk to Danny about that.

Steve

:up:

 

[SpeedDreamz.com]

Hey, that is my header in the pic. :silly:

Thanks DTR.

 

[2fastxeg]

the O2 bung should be right where the Y section of the header right where the megaphone is welded on to... i have even taken a look at the Skunk's full race header and they have it at the same spot right after teh merge collector