Honda / Acura K20a K24a Engine Forum banner

K20A2 EG Canadian Car

2115 Views 17 Replies 6 Participants Last post by  eg6k20a2
Anybody here done the swap in a Canadian car ???

I am currently finalizing my Hybrid Racing wire harness and they say in their manual :
"24 . If you are running a Canadian model EG/DC cut C101 pin 14"

If I'm right C101 is the big grey connector near the ECU on the right side of the dash coming from my K engine harness, which is plugged to a connector that goes to the driver side. And at pin 14 there are 2 YEL/BLK wires.

I just wanna make sure I really need to cut those 2 wires in my canadian body, and that I got the correct connector and wires.
1 - 2 of 18 Posts
I don't remember having to do this on my EG. My suggestion would be to contact Will from HR with this question.

He'll sort this out for you. :up:
I'm telling you man, Call Will @ Hybrid Racing, he can answer any harness questions you have.
1 - 2 of 18 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.