Honda / Acura K20a K24a Engine Forum banner
1 - 2 of 2 Posts

· Registered
380 Posts
Discussion Starter · #1 ·
Having trouble looking for the Spec's of a k20-R Valve clearance. Dont know if its the same as the USDM motors, but when i measured mine ALL the intake was at .005 inches and ALL the Exhaust .007 inches...was just wondering if it was correct or should i follow the USDM? all info will be greatly appreciated Thanks
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.