Honda / Acura K20a K24a Engine Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
5 Posts
no it wont bolt in but there are ways to make anything work i mean i have seen some kits that were custom fab that were just steel plates so if you had the engine and had the time you could mock up something of have a local custom fab shop do it it really isnt that hard it is just a matter of time and money and see if it would even fit prob have to do some major hood mods to get it to close but good luck
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top