Honda / Acura K20a K24a Engine Forum banner

K-Tuned Front Stabilizer bars for 88-91 Civic / CRX

16K views 42 replies 15 participants last post by  Mike@K-Tuned 
What are you guys making for the EG? If i'm not mistaken the setup for the EF/CRX basically makes the lower control arm in to a wishbone or A arm style control arm?

With more than one point mounting to the chassis it should be more solidly mounted and create less deflection... The traction bars do the same thing from what I understand but adding a thrid mounting point.

With the EG, DC, or Ek chassis they already have a double wihsbone front suspension setup. So are you looking at adding a 3rd pickup point for the lower control arm not counting the traction bars, with the traction bars being the fourth?
 
So the whole front LCA will be aluminum bar? Sounds interesting...
 
Ok gotcha...

You guys going to incorperate any type of sway bar mounting point on them?

Just to be accurate the EK ones are all 2 piece except the SI. The SI is a one piece and the sway bar mounting points on all the other models are located on the rear piece you are reffering to replacing...
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top