Honda / Acura K20a K24a Engine Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
I bought these camshafts used from skunk 2. I was told they were barely used, no more than 1000 Miles. It was used on a few pulls if anything. These are also early production camshafts from skunk2, not much difference from the current ones on the website. These are also both Intake and Exhaust camshafts.

These will work for: K20A, K20A2, K20Z1, K20Z3 Heads (not so sure about K24)
Part # 305-05-0225

New Price: 200 Shipped! (including paypal fees + shipping)
(These are wrapped and boxed ready to go, they weigh ~ 10lbs each so 20 lbs in total)






The last picture if you cant see it, its a "2" and "I"
 

·
Banned
Joined
·
219 Posts
Hows Da Feed Back On These Cams And Comparison Compared 2 Da New Ones Very Interested And Where U Located
 

·
Registered
Joined
·
7 Posts
Discussion Starter #3
Hows Da Feed Back On These Cams And Comparison Compared 2 Da New Ones Very Interested And Where U Located
when i talked to the represenatives there, they said the comparisons arent that much of a difference, they said maybe a couple-few angles different, slightly bigger lobes (new ones) but as far as performance, they said it was around 5 hp
 
1 - 10 of 10 Posts
Top