Honda / Acura K20a K24a Engine Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter · #1 ·
I understand that you need to run the cable linkage through to the tranny. When you drill the hole for the linkage (i read somewhere) that you need to be very carefull not to hit the main wiring in the frame. Is there a different way to do this? Or any tricks for doing it? I haven't seen this discussed in a while.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top