Honda / Acura K20a K24a Engine Forum banner
Cancel

Installing DTR Fab Header in EG, having problems...

2050 Views 13 Replies 10 Participants Last post by  Soda Popinski, 
S
Hey guys, just wanted to know how you guys got your DTR fab headers in while the motor was in the car. I just tried to test fit it in place and i just cant get through the area where the crossmember is and the halfshaft. Do any of you guys have some times i should give a shot?
Reply
Save
Like
1 - 1 of 14 Posts
02sik24a2
supafly said:
if your shield is still on the mid shaft... remove it.

otherwise you have to twist it should fit... just takes some movement.
Click to expand...
those sheilds are stupid anyways....3.5" off the block...waste of space
Reply
Save
Like
1 - 1 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Honda / Acura K20a K24a Engine Forum
A forum community dedicated to Honda and Acura K Series engine platform owners and enthusiasts. Come join the discussion about performance, modifications, troubleshooting, power-adders, racing, maintenance, and more!
Full Forum Listing
Explore Our Forums
Parts for sale All Motor K series Technical Discussion 1992+ Civic EG / DC2 / EK K-Series Swap General K-series related talk Parts Wanted
Top