you do not need to remove the halfshaft, just the shield, it looks hard at first but you just have to jack up the car real high and have the headers facing flat and enter the top first then rotate them while going upwards. just jack up the car high and you will see. no need to remove shit.
Installing DTR Fab Header in EG, having problems...
Hey guys, just wanted to know how you guys got your DTR fab headers in while the motor was in the car. I just tried to test fit it in place and i just cant get through the area where the crossmember is and the halfshaft. Do any of you guys have some times i should give a shot?
1 - 2 of 14 Posts
nah he's still jerkin off with it ! 
1 - 2 of 14 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Honda / Acura K20a K24a Engine Forum
A forum community dedicated to Honda and Acura K Series engine platform owners and enthusiasts. Come join the discussion about performance, modifications, troubleshooting, power-adders, racing, maintenance, and more!
Full Forum Listing
Top Contributors this Month
View All
mattkosem
87 Replies
Brotatochip
80 Replies
gotovato
71 Replies
Recommended Communities
